Dome Port Calculation
A dome port works best when the centre of curvature of the dome sits exactly on the entrance pupil of the lens. The planner below draws the setup to scale and shows how close each combination of extension rings comes to that ideal, and what is in focus. For details, see the page on wide-angle photography.
How it works
Choose a dome (or its outer radius), a lens, the sensor format and the aperture, then tick the extension rings. Use the two sliders to set the focal length and the focus distance, from the closest possible focus to infinity, measured from the front of the dome.
The planner shows where the dome's centre sits relative to the entrance pupil, whether the dome rim or a port's inner tube cuts the FX (green) or DX (red) field, how close the lens can focus, and the depth of field. The drawing shows the subjects that are sharp, the virtual image behind the dome that the lens actually focuses on, and how much of a flat wall at the focus distance is sharp. Optimal extension is the ring length that puts the centre exactly on the pupil. The table below the drawing lists the three ring combinations with the smallest offset across the zoom range.
Limitations
The geometry applies to Nikon Z cameras in Aquatica Z housings and was measured on a Z8 in an AZ8. Dome radii and positions come from photos and measurements (about ±2–3 mm). The dome is treated as a thin spherical shell. The lenses' own field curvature is included as measured in air for the 8–15 fisheye and the Z 17–28; other lenses are treated as flat. "Sharp" means a blur of at most 0.03 mm (FX) or 0.02 mm (DX) on the sensor, the usual standard for a print. Treat the results as a starting point and confirm every setup in the pool.
This planner is provided as is, for information only. I accept no liability for errors or for any consequences of using its results.